Ashley-Edison M2 Manuale Utente Scaricare il pdf (Pagina 7)

ASHLEY-EDISON (UK)

Manufacturers of Voltage Stabilisers – Power Conditioners – Constant Voltage Compensators – Variable Transformers

OSES THREE PHASE OPERATOR MANUAL - EN

Issue No: AE/OSES-3P/TP/07/2011

- Page 7 of 37-

2. SAFETY NOTE

2.1 INTRODUCTION

These instructions are addressed to the Installer and End User / Operator of the OSES

Series of Three Phase AC Voltage Stabiliser / Regulator. We strongly suggest you

keep this manual next to the Stabiliser for future reference.

2.2 GENERAL – INSTALLATION & USAGE

• Do not use the Stabiliser for other than the intended use.

• Do not install stabiliser in a backfeed circuit to the grid, input voltage supply

cannot be connected to the output of stabiliser

• If on delivery there is evidence of visible damage, do not attempt to install or start

the Stabiliser. Advise the transport delivery company and inform Ashley-Edison,

or the resale partner from whom you purchased the equipment.

• The Stabiliser can contain potentially dangerous voltages – up to 600 V AC. Use

extreme caution when opening the covers and do not leave the unit unattended

with the doors open or covers off.

• Hazardous voltages can be present at the unit’s output any time AC input power

is applied. To avoid possible personal injury, or equipment damage, and to make

certain there is no output voltage, turn the unit off and disconnect the AC Input.

• Do not allow liquids or foreign objects to enter the unit.

• The installation and use of this product must comply with all relevant current

electrical installations that are in force in the territory of installation.

• Only qualified electrician shall install the equipment. The electrician shall install

the AC input according to the instructions contained in this manual. Standard

safety practices should be followed at all times.

• The unit must be grounded or earthed at all times when in use.

• Do not operate the Bypass Control Switch (or optional inbuilt Manual Bypass

Switch, if fitted) when the Stabiliser is supporting load, as severe damage can be

caused to the equipment and potentially the load. Load to be switched OFF

before operating bypass switches.

• If an External Manual Bypass Switch is to be used with the unit, the bypass switch

must be installed according to the Installation Instructions supplied with the

switch. Before operating the switch the input supply should be checked for the

correct phase rotation.

1 2 3 4 5 6 7 8 9 10 11 12 ... 36 37

Nessun commento

Ashley-Edison M2 Manuale Utente Pagina 7